Hach SIGMA 900 User Manual download pdf (Page 34)

Page 34

Re-installing the Bottom Panel

8544Maintenance.fm

Section 5

4. Place the controller, face down, on a cloth-covered workbench to prevent

scratching the front panel.

5. Inside the Center Section, remove the four screws that fasten the

Controller.

6. Lift the Center Section off the controller.

7. Remove the 17 screws from around the perimeter of the controller

back

panel.

8. Carefully pull open the bottom panel and let the attached connectors

swing out of the way.

9. If necessary for the repair being performed, unplug the appropriate

connectors. Always note each connector location before unplugging

anything. Re-installing a plug into the wrong connector can cause

extensive damage.

Note: The front panel gasket has a light coating of grease to help assure a watertight

seal. Do not contaminate the grease or gasket area with dirt or debris during

servicing. Always replace the gasket if it is damaged or missing. Never

reassemble the case without the gasket properly installed.

5.7 Re-installing the Bottom Panel

Note: Always follow the procedure below when re-installing the 900 bottom panel.

Improper panel installation may result in damage to the instrument.

1. Hand tighten each nut until it makes contact with the panel.

2. Tighten the nuts in sequence shown in Figure 9 to 5 in.-lb (0.56 N-m).

3. Repeat the tightening procedure in the same sequence to 10 in.-lb

(1.13

N-m).

Figure 9 Tightening the Nuts on the Bottom Panel

110 2

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 51 52

No comments

Hach SIGMA 900 User Manual Page 34